Programmable E Bike Electric Brushless Motor Controller

Programmable_E_Bike_Electric_Brushless_Motor_Controller_01_ozq
Programmable E Bike Electric Brushless Motor Controller
Programmable E Bike Electric Brushless Motor Controller

Programmable E Bike Electric Brushless Motor Controller
PROGRAMMABLE E BIKE ELECTRIC BRUSHLESS MOTOR CONTROLLER. FOC-180sinusoidal drive controller applied to BLDCM or PMSM. The motor torque ripple will be reduced to the minimum, so as to ensure electric vehicle to run without any noise and vibration, smoothly, and comfortably. The precise current ring can provide accurate torque input to meet the requirement 0f large torque output during vehicle starting and climbing. The controller enjoys high efficiency due to space vector converter control algorithm which can effectively reduce the temperature rise of controller and extend battery life mileage. Built-in various protection: locked-rotor protection, over-current protection, overload protection, over-temperature protection, speed protection, over-voltage protection , under-voltage protection and so on, effectively ensuring the safety of electronic control system and vehicle. System status and fault intelligent management system can effectively monitor the current system operating mode external input state , the case of system failure, and the LED flashes at the same time to facilitate the diagnosis and maintenance. The rich peripheral interfaces: reverse, cruise, anti-theft, electronic brake, etc. Parameter modifications and settings are available through online configuration with online computer 10. Voltage input range 36120V, power range:13kw 11. Installation method: internal, external. After receiving the item, you can start a return within: 30 days. The maximum dc current allowed. Maximum working phase current. 80–limit the current100 stop working. Hall sensor power supply requirement. Hall sensor installation requirement. High brake voltage input ranges. Throttle signal voltage input ranges. Auto match with the hall angle test in the PC software. The controller installation should take consider of the heat dissipation and ventilation to avoid water spatter. 1- Pls check closely the diagram when start the wire connection. 2- The power switch and the main contactor should be shut off during the connection. 3- When power on the red LED should always be on. The item “PROGRAMMABLE E BIKE ELECTRIC BRUSHLESS MOTOR CONTROLLER” is in sale since Tuesday, October 29, 2019. This item is in the category “Sporting Goods\Cycling\Bike Components & Parts\Electric Bike Components”. The seller is “leeafco” and is located in Alton. This item can be shipped to all countries in Europe.
  • Colour: Silver
  • Country/Region of Manufacture: China
  • Type: Electric Controller
  • MPN: SVMC7240
  • For Bike Type: Electric Bike
  • Brand: Elite Bikes
  • Electric Bike Part Type: Motor

Programmable E Bike Electric Brushless Motor Controller